Schneider Electric (Xantrex)
Charge Controllers
Xantrex C-35, C-40 and C-60 PWM Controllers
The Xantrex C-35, C-40, and C-60 PWM (Pulse Width Modulator) controllers can be used as PV charge controllers, DC load controllers or DC diversion regulators in 12, 24 volt systems. The C-40 can be used in 48 volt systems as well. They operate in only one mode at a time, so two controllers must be used to provide both PV charge controller and low battery load disconnect.
As DC load controllers they disconnect the load at a user-settable low voltage and reconnect at a higher voltage reconnect point. As diversion controllers they send excess power to a “dummy load” (such as a water or space heater) to regulate hydroelectric or wind generators.
The optinal LCD digital display shows battery voltage, array amps and watts, cumulative amp-hours and a separately resettable “trip” amp-hour measurement. UL Listed. 2-year warranty.
Xantrex C-12 Charge, Lighting, or Load Controller
As a charge controller, it features three-stage charging, user definable voltage parameters, and automatic equalization. Standard in the C12's load control circuitry are field adjustable low voltage disconnect and reconnect points, along with a five minute low battery disconnect warning. The Xantrex C-12 controller is PWM microprocessor-based and ideal for small village power systems, vacation homes, outdoor area lighting, sign lighting, and bus shelters. The lighting control turns the light on at dusk, then has an adjustable duration timer for 2 to 8 hours of run time, or can be set to run all night. If the battery gets low, lights are turned off. User-adjustable LVD set points. For use in 12 volt systems only. Can be mounted outdoors. UL Listed. 2-year warranty.
Xantrex XW-MPPT60-150 Charge Controller

The XW MPPT can be used with 12, 24, 36, 48, and 60-volt DC battery systems and is able to charge a lower nominal-voltage battery from a higher nominal-voltage array. For example, the XW MPPT can charge a 12-volt battery from a 36-volt array. This provides flexibility for installers to use longer wiring runs without compromising efficiency. The XW Solar Charge Controller can be installed (in single or multi-unit configurations) with Xantrex XW Hybrid Inverter/Charger(s) or can be used in other solar energy systems where a solar charge controller is needed.
Array size can be up to 750 watts when charging a 12 volt battery bank, 1,500 watts when charging an 24 volts, and 3,000 watts when charging at 48 volts.
$569.00
Array size can be up to 750 watts when charging a 12 volt battery bank, 1,500 watts when charging an 24 volts, and 3,000 watts when charging at 48 volts.
$569.00