Xantrex XW4024 Inverter with accessories (not included)
|
Xantrex XW4024-120/240-60 Hybrid 4000W, 24VDC, 120/240 VAC, 60 Hz, Off-Grid/Grid-Tie (Hybrid) Inverter, Pure Sine Wave, 150A charger
Grid-Interactive and Stand-alone capability in the same package This product offers a complete power conversion system between batteries and AC power. It can provide backup power, sell power back to the utility grid, or provide complete stand-alone off-grid service. Applications The Xantrex XW Inverter/Charger is a modular building block sine-wave inverter/charger that can be used for both residential and commercial stand-alone, grid-backup, and grid-tie applications with battery energy storage. The Xantrex XW Series Inverter/Charger is a self-contained DC to AC inverter, battery charger, and AC transfer switch. Up to four inverters can be installed in parallel to create larger 120-240 volt, 3-wire, single-phase systems allowing for increased capacity. The XW’s dual AC inputs make it simple for dealers to use with generators in hybrid grid-tie, or with generator/micro hydro or dual genset applications. Complete system solution using modular components • The XW system is comprised of manageable building blocks; XW Inverter/Chargers, Solar Charge Controller, Power Distribution Panel, Conduit box, Automatic Generator Start module, and System Control Panel All system components are networked • XW Inverter/Chargers, XW Solar Charge Controllers, Automatic Generator Start modules, and System Control Panels communicate with each other out of the box Designed for rapid deployment • The XW Power Distribution Panel comes prewired with DC and AC breakers, ready to be connected to XW Inverter/Chargers and battery banks Enjoy superior after sales service: All XW system components are backed by a standard 5 year warranty with a 10 year optional extended warranty available Includes: • Mounting Panel • DC terminal Covers • Network Terminator • Battery Temperature Sensor • Air Filter • Mounting Hardware • AUX Port Connector A Battery Temperature Sensor (part number 808-0232-02) is also included with the Xantrex XW Inverter/Charger. The Battery Temperature Sensor monitors the temperature of the battery bank and adjusts the charging accordingly. Renewable Energy The XW4024 Inverter/Charger cannot connect directly to photovoltaic arrays, wind turbines, or other renewable sources. The batteries are the inverter’s primary source of power. However, if these sources are used to charge the batteries, the inverter can use their energy by drawing it from the batteries. The renewable source is always treated as a battery charger, even if all of its power is used immediately. The renewable source must have a charge controller or some way to prevent overcharging. Xantrex XW60-150 MPPT charge controller can be used for this purpose, as can other products. Features
Model XW4024-120/240-60L Continuous output power: 4000 Watt Surge rating (10 seconds): 8000 W Surge current: L-L: 35 Arms (20 sec) L-N: 75 Arms (20 sec) Waveform: True sine wave Low-load efficiency: 95% Idle consumption - search mode< 8 Watts AC connections: AC1 (Grid), AC2 (Generator) AC voltage: 120/240 Vac split-phase AC input breaker: 60 A two-pole Utility interactive: Yes CEC weighted efficiency: 91% CEC power rating: 4000 Watts AC input voltage range (bypass/charge mode) L-N: 80-150 Vac (120 V nominal); L-L: 160-270 Vac (240 V nominal) AC input frequency range (bypass/charge mode) 55-65 Hz (default); 44-70 Hz (allowable) AC1 voltage range – Sell mode L-N: 108-130 +/- 1.5 Vac; L-L: 214 - 260 +/- 3.0 Vac (automatically adjusts when entering Sell mode)* AC1 frequency range – Sell mode: 59.4 - 60.4 +/- 0.05 Hz (automatically adjusts when entering Sell mode)* AC output voltage: L-N: 120 Vac +/- 3%; L-L: 240 Vac +/- 3% AC output frequency: 60.0 +/-0.1 Hz DC current at rated power: 178 Amps Total harmonic distortion: < 5% Automatic transfer relay: 60 Amps Typical transfer time: 8 ms DC input voltage (nominal): 25.2 Vdc DC input voltage range: 22 - 32 Vdc Maximum continuous charge rate: 150 Amps Efficiency at maximum charge rate: 85.8% Power factor corrected charging: 0.98 Emissions: FCC Class B Multiple-unit configurations: Up to three parallel units in 120/240-volt split- phase configuration Auxiliary relay output: 0-12 Vdc, maximum 250 mA DC Non-volatile memory: Yes System network Xanbus™ (publish-subscribe network, no need for hubs or special cards) Mechanical Specifications Mounting: Wall mount, backplate included Inverter dimensions (H x W x D) 23 x 16 x 9” (580 x 410 x 230 mm) Inverter weight: 115 lb (55 kg) Display panel: Status LEDs indicate AC In status, faults/warnings, equalize mode, battery level. Three-character display indicates output power or charge current, fault/warning codes. On/Off and equalize buttons Battery temperature sensor: Included Standard warranty: Five years Part number: 865-1010 Environmental Specifications Enclosure type NEMA Type 1 – Indoor (sensitive electronic components sealed inside enclosure) Operational temperature range -13 to 158 °F (-25 to 70 °C) Accessories Remote display Optional XW System Control Panel monitors and configures all devices connected to Xanbus™ Network Generator support: Optional XW Automatic Generator Start module connects to Xanbus™ Network. Automatically activates generator to recharge depleted battery bank or assist inverter with heavy loads Power distribution & panel conduit boxes: Optional balance-of-systems components for NEC compliant installations, includes pre-wired AC and DC circuit breakers, bus barsand multiple knockouts for conduit and additional breakers Regulatory Approval UL 1741 1st Edition: 2005 Version CSA 107.1-01 Specifications subject to change without notice. Optional Accessories
Shipping dimensions: 28 x 22 ¼ x 10 ½” (711 x 565 x 267 mm) Shipping weight: 122 lb (55 kg) |
$1,525.00 + FREE FREIGHT SHIPPING Related Items
Xantrex XW Conduit Box
Xantrex XW Automatic Generator Start
|